Languages / Langues:
English / Anglais
French / Francais

RejeX - FISHNTECH



RejeX 12 oz.
Bottle

Price:
C$16.99



NOTHING STICKS BUT THE SHINE!®


RejeX
is a water-clear, ultra high release, thin film polymer coating that should be used instead of wax to maximize protection and shine. Less than a micron thick, this thin film coating resists stains and adhesion of common contaminants such as road film, exhaust soot, bug spalts, bird droppings, brake dust, tree sap, pollen, tar and grease. RejeX is even effective against the dreaded love bugs! It is suitable for vehicles of all sorts, including aircraft, cars, motorcycles, boats, and RVs. It can also be applied to windshields to repel rain. It’s easy to apply and produces a deep, lustrous shine that outlasts wax-based products by months.


RejeX contains none of the free silicone oils found in some other polymer products that are known to contaminate paint and cause problems when repainting.

RejeX PROTECTS AND BEAUTIFIES PAINTED METAL, GLASS, ACRYLIC, GEL COAT, FIBERGLASS, GLOSSY PLASTIC & POLISHED METAL SURFACES

RejeX is not meant to be used on porous surfaces or highly oxidized painted surfaces. RejeX can be applied in multiple coats, allowing at least 8 hours curing time between coats, for greater depth of gloss. RejeX has a higher refractive index than waxes, so it produces richer, deeper looking colors and a lustrous long-lasting finish. It is especially notable on dark colors and metallic paints where RejeX brings out accurate color and detail in the paint.

RejeX can be used over existing wax; however, the duration of protection will be reduced as the softer underlying wax degrades comparatively quickly. There is no reason to wax over RejeX. RejeX leaves a shinier, longer-lasting finish than wax… and wax can't adhere well to RejeX!

If a RejeX-treated surface needs repainting, normal paint preparation is all that’s required. Abrasive cleaners, polishes, rubbing compounds or chemical paint strippers will remove the RejeX film.


RejeX Application:

RejeX should be applied to a cool, dry surface out of direct sunlight when ambient temperatures are above 85° F. If the surface is too hot, the coating will dry before it has properly bonded to the surface, and it won’t perform up to its potential. RejeX is wiped on, allowed to dry to a haze for approximately 20 minutes, wiped off, then allowed to cure for 8-12 hours (depending on the humidity).

Curing is required to allow the monomers (polymer building blocks) that make up RejeX to attach to the surface being treated and to polymerize (crosslink) into a crystal-clear, impervious film. It is very important to allow RejeX to cure for 8-12 hours after the haze has been wiped off. If the coating is exposed to contamination such as oil, fuel, soo
t, water, cleaners, etc. before it has cured, the contaminants may interfere with or embed within the protective coating.
 


You might also be interested in


 


T-H Marine
Cook's Tackle System


Stowmaster
Landing Nets


The Oxygenator
Pro Live Well Flush Mount
Solution Graphics

PayPal Acceptance Mark



FISHNTECH, LACHUTE, QUEBEC, CANADA
 

Website Builder